Product Description
1m Cat6 U/UTP patch lead — spec sheet for panel and camera runs
A short RJ45-to-RJ45 patch cable for tidying up NVR-to-switch, PoE injector, or rack-to-panel connections where a full-length run isn't needed.
Key specs
- Type: Cat.6, U/UTP (unshielded twisted pair), rated to 250MHz bandwidth
- Conductor: Copper, 24AWG
- Attenuation: 32.8dB/100m @250MHz
- Jacket: PVC, 5.8mm diameter
- Connectors: RJ45 male both ends, polycarbonate housing, gold-plated copper alloy pins
- Minimum bend radius: 69mm
- Operating range: -10°C to 60°C; storage -20°C to 75°C
- Length: 1m; Colour: White
Where it fits on a job
At 1m this is a patch lead, not a backbone cable — use it for switch-to-patch-panel jumpers, NVR-to-router hops, or dressing a rack neatly rather than for long camera runs. The U/UTP build has no shielding, so keep it clear of high-EMI sources if routing near mains or motor cabling.
PoE note
No PoE rating is specified for this lead. Where PoE cameras are involved, base your power budget on the injector/switch and the full cable run length rather than this patch cable in isolation — voltage drop on long runs is a function of total cable length and gauge, not this 1m section.
Gold-plated pins and a polycarbonate connector housing are standard on this range for a low-resistance, durable connection point in patch panel and rack environments.
Specifications
- Cable Category
- CAT6
- Length
- 1m
- Colour
- White
- Connector Type
- RJ45
- Material
- Polycarbonate
Frequently Asked Questions
Is this cable shielded?
No — it's U/UTP (unshielded twisted pair) construction, per the cable's build spec.
What's the conductor gauge and material?
24AWG copper conductors, as listed in the cable construction spec.
What bend radius should I allow when routing this in a rack?
The specified minimum bend radius is 69mm (2.72in) — stay above this to avoid signal degradation or jacket stress.
Is this cable rated for PoE current?
No PoE rating is given in the specification; for PoE camera runs, size your power budget against the full run length and your injector/switch rating rather than this 1m lead alone.
